Use To
Print Recovery (Continued)
Jam Recovery
On
Off
Auto
Specify whether the printer reprints jammed pages.
Notes:
• Auto is the factory default setting. The printer reprints
jammed pages unless the memory required to hold the
pages is needed for other printer tasks.
• On sets the printer to always reprint jammed pages.
• Off sets the printer to never reprint jammed pages.
Print Recovery (Continued)
Page Protect
Off
On
Let the printer successfully print a page that may not have printed
otherwise.
Notes:
• Off is the factory default setting. Off prints a partial page
when there is not enough memory to print the whole page.
• On sets the printer to process the whole page so that the
entire page prints.
Hibernate Timeout on Connection
Hibernate
Do Not Hibernate
Set the printer to follow the setting of “Hibernate Timeout” even
when an active Ethernet connection exists.
Notes:
• If “Hibernate Timeout on Connection” is set to “Do Not
Hibernate,” then the device never automatically hibernates.
• If “Hibernate Timeout on Connection” is set to “Hibernate,”
then the device follows the value of the “Hibernate Timeout”
setting, except when it is set to Disabled.
• “Do Not Hibernate” is the factory default setting.
Press Sleep Button
Do Nothing
Sleep
Hibernate
Determine how the printer, while in idle state, reacts to a short
press of the Sleep button.
Note: Sleep is the factory default setting.
Press and Hold Sleep Button
Do Nothing
Sleep
Hibernate
Determine how the printer, while in idle state, reacts to a long press
of the Sleep button.
Note: “Do nothing” is the factory default setting.
GUI Log Level
Everything (0)
Keys (1)
Debug (2)
Warnings (3)
Errors (4)
Critical (5)
System Info (6)
Store the amount of log files populated from the GUI component,
where each log entry is marked at a certain level.
Understanding the printer menus 107
To Next Page
Loading...
Need help?
General
