Lexmark MS415 - Base Sensor Test; Device Tests; Flash Test

Base Sensor Test
Use this to determine that the sensors located inside the printer are operating correctly.
The following sensors can be checked using this test:
• Narrow Media
• Input
• Exit/Output
• Front Door
CAUTION—SHOCK HAZARD: Do not use your hand to toggle these switches. Use a nonconducting item.
To run the test:
1 From the Diagnostics menu, navigate to Base Sensor Test.
2 Choose a sensor.
3 Manually actuate the sensor to verify that it toggles. If the sensor does not toggle, then it is malfunctioning.
Sensor Values
Input
Exit/Output
Front Door
Open
Closed
Narrow Media Narrow
Wide
4 Press X to exit the test.
Device Tests
Flash Test
This test verifies the condition of the flash device by writing data to it and then reading data from it.
Warning—Potential Damage: This test destroys all data on the flash device.
Note: After this test is executed, reformat the flash using the Flash Format setting in the Utilities menu.
1 From the Diagnostics menu, navigate to:
Device Tests > Flash Test
Contents will be lost. continue? appears.
2 Select Yes to continue the test, or select No to return to the Device tests menu.
3 After the test is complete, the result appears.
4 Reformat the flash device using the Flash format setting in the Utilities menu.
4514
Service menus
128