Lexmark MS415 - ACM Assembly Removal

g Pull the free end to make sure that the cable is tightly looped around the cable holders.
h Route the cable using the new path, and secure it with a cable tie (A).
A
ACM assembly removal
1 Remove the left cover. See “Left cover removal” on page 168.
2 Remove the main drive gearbox. See “Main drive gearbox removal” on page 169.
3 Remove the rear door and cover. See “Rear door and cover removal” on page 232.
4 Remove the power supply. See “Power supply removal” on page 216.
5 Remove the power supply shield. See “Power supply shield removal” on page 217.
4514
Repair information
226