Lexmark MS415 - Skewed Print Check

Actions Yes No
Step 4
Check the following fuser components for wear or damage:
• Gears
• Exit rollers
• Belt fuser
Are they free of damage?
Go to step 5. Replace the fuser. See
“Fuser removal” on
page 238.
Step 5
a Turn off the printer.
b Remove the rear door and cover.
c Disconnect the fuser cable connected to PCN5 of the power supply.
d Check for approximate correct resistance on the fuser cable:
• 220 V fuser—43 ohms
• 110 V fuser—10 ohms
• 100 V fuser—8 ohms
Is the resistance equal to any of the above values?
The problem is solved. Replace the fuser. See
“Fuser removal” on
page 238.
Skewed print check
) )
ABCDE
ABCDE
ABCDE
Actions Yes No
Step 1
a POR into the Diagnostics menu and perform a print test:
Diagnostics Menu > Print Tests > Tray 1
b Adjust the margins if necessary:
Diagnostics Menu > Registration
Does the error remain?
Go to step 2. The problem is solved.
Step 2
Does the skew appear every two pages?
Go to step 9. Go to step 3.
Step 3
Check the media source.
Is the media from Tray 1?
Go to step 4. If the media is from the
MPF, then go to step 6.
4514
Diagnostic information
36