Actions Yes No
Step 4
Make sure the pick tires are free of debris. Check for wear or damage.
Are they free of wear or damage?
Go to step 5. Replace the pick tires.
Step 5
Check the lift plate on the input tray for damage.
Is it free of damage?
Go to step 11. Replace the input tray.
Step 6
Make sure the MPF pick roller and separator pad are free of debris. Check
for wear or damage.
Are they free of wear or damage?
Go to step 7. Replace the MPF pick
roller and separator
pad. See
“MPF pick
roller removal” on
page 206 and
“Separator pad
removal” on page
214.
Step 7
Check the MPF gearbox for wear or damage.
Is it free of wear or damage?
Go to step 8. Replace the MPF
gearbox. See
“MPF
gearbox removal” on
page 174.
Step 8
Make sure the front input guide rollers are free of debris. Check for wear
or damage.
Are they free of wear or damage?
Go to step 11. Replace the front input
guide. See
“Front input
guide removal” on
page 212.
Step 9
Make sure the redrive rollers are free of debris. Check for wear or damage.
Are they free of wear or damage?
Go to step 10. Replace the redrive
assembly. See
“Redrive
assembly removal” on
page 235.
Step 10
a Remove the left cover.
b POR into the Diagnostics menu and perform a duplex test:
Diagnostics Menu > Duplex Tests
c Observe the reverse solenoid for proper operation.
Does it properly operate?
Go to step 11. Replace the reverse
solenoid. See
“Reverse
solenoid removal” on
page 177.
Step 11
Make sure the input roller/deskew assembly is free of debris. Check for
wear or damage.
Is it free of wear or damage?
Contact the next level
of support.
Replace the printer.
4514
Diagnostic information
37
To Next Page
Loading...
