UICC removal
1 Remove the right cover. See “Right cover removal” on page 185.
2 Remove the nameplate. See “Nameplate removal” on page 199.
3 Remove the bezel. See “Bezel removal” on page 198.
4 Remove the control panel assembly. See “Control panel assembly removal” on page 199.
5 Remove the cable from the connector (A).
6 Remove the eight screws (B).
B
B
A
7 Flip the UICC, and then remove the screw (C).
C
Note: The control panel cover, buttons, and light pipe are not included with the UICC.
4514
Repair information
202
To Next Page
Loading...
