This restores all network NVRAM settings. The printer immediately performs a POR and restores the appropriate settings
to their factory default values. This option is available only on models with an integrated network adapter.
Energy Conserve
This setting controls which values appear on the Power Saver menu.
To change the setting:
1 From the Configuration menu, navigate to Energy Conserve.
2 Select On or Off.
If On (default), then the Sleep Mode cannot be turned off. If Off, then Disabled appears on the Sleep Mode
menu, and it can be turned off.
Paper Prompts
This controls which tray a change prompt is directed to when paper is sensed to be the wrong size.
Note: The value of
“Action for Prompts” on page 137 may override the value of this setting.
To change this setting:
1 From the Configuration menu, navigate to Paper Prompts.
2 Select from the available options:
• Auto (default)
• Multi‑purpose Feeder
• Manual Paper
3 Depending on the printer model, press OK to save the setting, or press X to return to the Configuration menu
without saving any changes.
When it is set to Auto, the emulator selected to print the job determines which of the installed input sources will receive
the change prompt. When set to a value other than Auto, the selected source always receives this type of prompt.
Envelope Prompts
This controls which tray a change prompt is directed to when the envelopes are sensed to be the wrong size.
Note: The value of
“Action for Prompts” on page 137 may override the value of this setting.
To change this setting:
1 From the Configuration menu, navigate to Envelope Prompts.
2 Select from the available options:
• Auto (default)
• Multi‑purpose Feeder
• Manual Envelope
3 Depending on the printer model, press OK to save the setting, or press X to return to the Configuration menu
without saving any changes.
4514
Service menus
136
To Next Page
Loading...
