Lexmark MS415 - Insufficient Memory Service Check

Action Yes No
Step 5
POR into the Diagnostics menu and perform a sensor test:
Diagnostics Menu > Base Sensor Test > Narrow Media
Does the sensor state on the control panel display change when it is
toggled?
Go to step 6. Replace the narrow
media/bin full sensor.
See
“Narrow
media/bin full sensor
removal” on page
233.
Step 6
a Remove the main drive gearbox.
b Check the gears for wear or damage.
c Check the main drive motor for rotation.
Are the gears free of wear or damage and does the main drive motor
rotate?
Go to step 7. Replace the main drive
gearbox. See
“Main
drive gearbox
removal” on page
169.
Step 7
Replace the controller board.
Does the error remain?
Problem is solved. Contact the next level
of support.
Insufficient memory service check
Action Yes No
Step 1
Disable the Resource save feature:
Settings > Print Settings > Setup Menu > Resource Save > Off
Does the problem remain?
Go to step 2. The problem is solved.
Step 2
Check the memory card for proper installation.
Is it properly installed?
Go to step 3. Reseat the memory
card.
Step 3
a Print the Menu settings page:
Settings > Reports > Menu Settings Page
b POR into the Configuration menu and reset the printer’s settings to
factory default:
Configuration Menu > Factory Defaults > Restore Base
c Remove the memory card.
d Restart the printer.
Does the error remain?
Replace the controller
board. See
“Controller
board removal” on
page 187.
Replace the memory
card.
4514
Diagnostic information
82