Load Manual Feeder with [paper size] [orientation]
Try one or more of the following:
• Load the feeder with the correct size of paper.
• From the printer control panel, press to clear the message and continue printing.
Note: If no paper is loaded in the feeder, then the printer manually overrides the request, and then prints from
an automatically selected tray.
• Cancel the current job.
Load Manual Feeder with [paper type] [paper size] [orientation]
Try one or more of the following:
• Load the feeder with the correct size and type of paper.
• From the printer control panel, press to clear the message and continue printing.
Note: If no paper is loaded in the feeder, then the printer manually overrides the request, and then prints from
an automatically selected tray.
• Cancel the current job.
Memory full [38]
Try one or more of the following:
• From the printer control panel, press to clear the message.
• Decrease the resolution setting.
• Install additional printer memory.
Network [x] software error [54]
Try one or more of the following:
• From the control panel, press to continue printing.
• Turn off the printer, wait for about 10 seconds, and then turn the printer back on.
• Update the network firmware in the printer or print server. For more information, go to
http://support.lexmark.com.
Non‑Lexmark [supply type], see User’s Guide [33.xy]
Note: The supply type can either be a toner cartridge or an imaging unit.
The printer has detected a non‑Lexmark supply or part installed in the printer.
Your Lexmark printer is designed to function best with genuine Lexmark supplies and parts. Use of third-party supplies
or parts may affect the performance, reliability, or life of the printer and its imaging components.
4514
Diagnostic information
72
To Next Page
Loading...
