Lexmark MS415 - Page 47

Error code Description Action
200.30 Invalid printhead NVRAM. Go to
“Sensor (input) image jam service check” on
page 49.
200.31 Paper, in the middle of a job, at input sensor before
interrupt occurred.
Go to
“Sensor (input) early/late arriving service
check” on page 48.
200.32 Detected cover switch bounce. Go to
“Sensor (input) early/late arriving service
check” on page 48.
200.33 Input sensor covered too quickly. Go to
“Sensor (input) early/late arriving service
check” on page 48.
200.38 Interpage servo gap smaller than expected for galvo
offset target evaluation.
Go to
“Sensor (input) early/late arriving service
check” on page 48.
200.42 Rogue sheet at ACM sensor while flushing the paper
path prior to declaring tray 1 source empty.
Go to
“Sensor (input) early/late arriving service
check” on page 48.
200.84 Image data did not start on time. Go to
“Sensor (input) image jam service check” on
page 49.
200.87 During warm up flush, sheet detected too long over
input sensor.
Go to
“Sensor (input) early/late arriving service
check” on page 48.
Sensor (input) static jam service check
Action Yes No
Step 1
Check the input sensor area for jammed media fragments.
Is the paper path free of partially fed or jammed media?
Go to step 2. Clear the paper path of
any media fragments.
Step 2
Check the jam access cover if it is blocking the input sensor.
Is it blocking the input sensor?
Replace the jam access
cover. See
“Jam access
cover removal” on
page 207.
Go to step 3.
Step 3
Check the input sensor cable for proper connection.
Is it properly connected?
Go to step 4. Reseat the cable.
Step 4
POR into the Diagnostics menu and perform a sensor test:
Diagnostics Menu > Base Sensor Test > Input.
Does the sensor state on the control panel display change when it is
toggled?
Go to step 5. Replace the input
sensor. See
“Duplex
sensor and input
sensor removal” on
page 219.
Step 5
Does the error remain?
Contact the next level
of support.
The problem is solved.
4514
Diagnostic information
47