Lexmark MS415 - Page 86

Error code Description Action
111.60 Closed-loop printhead sweep error, check sweep
accuracy state.
Go to
“LSU service check” on page 86.
111.61 Printhead drive control out of range due to an
external event beyond what the control is designed
to handle.
111.62 Closed-loop printhead error, off-resonant PI effort
state.
111.63 Timed out on POR sweep.
111.64 Attempted to exceed open loop drive limits.
111.65 Attempted to exceed open loop drive limits.
111.66 Failed alignment of printhead.
111.67 Attempted to exceed open loop drive limits.
111.68 Too many fake HSYNCs while aligning printhead.
111.69 Attempted to exceed open loop drive limits.
LSU service check
Action Yes No
Step 1
Check the LSU cables JVIDEO1 and JGLV1 for proper connection.
Are they properly connected?
Go to step 2. Reseat the cables.
Step 2
Inspect the LSU cables and connectors.
Are they free of damage?
Replace the controller
board. See
“Controller
board removal” on
page 187.
Replace the LSU. See
“Laser scanning unit
(LSU) removal” on
page 240.
4514
Diagnostic information
86