Lexmark MS826 - Sensor (250- and 550-Sheet Tray Pass-Through) Removal; Sensor (250- and 550-Sheet Tray Pick) Removal

4 Remove the two screws (B), and then remove the controller board.
Sensor (250‑ and 550-sheet tray pass‑through) removal
1 Remove the tray insert.
2 Remove the screw (A), and then disconnect the sensor cable (B).
3 Remove the sensor.
Sensor (250‑ and 550-sheet tray pick) removal
1 Remove the tray insert.
2 Remove the pick roller. See “Pick roller removal” on page 503.
4064
Parts removal
507