Lexmark MX911dte - Sensor (2 X 500-Sheet Tray Paper Width) Removal

# Part
1 Sensor (2 x 500-sheet tray 3 near empty)
2 Sensor (2 x 500-sheet tray 4 near empty)
Sensor (2 x 500-sheet tray paper width) removal
1 Remove the rear cover. See “2 x 500-sheet tray rear cover removal” on page 483.
2 Remove the screw.
3 Disconnect the cable from the sensor, and then remove the sensor holder.
# Part
1 Sensor (2 x 500-sheet tray 3 paper width)
2 Sensor (2 x 500-sheet tray 4 paper width)
7421
Repair information
485