7 300781172_002_C0 - 01/2019 - © Leybold
Before using this instrument
WARNING:
Before turning on power, make sure that the operating voltage and supply
voltage are the same. If incorrect power is applied, damage or fire could result.
WARNING:
Whenever replacing a fuse, turn off the power. If a fuse is replaced with power
turned on, you can receive an electric shock.
WARNING:
Risk of fire. The specified fuses protect this equipment against fire. Only use the
specified fuses and never short circuit the fuse holder.
WARNING:
If the product is damaged, turn off power immediately. Continued use can result in
fire or electric shock.
WARNING:
If the product is overheated or produces smoke or an unusual smell, turn off the
power immediately. Continued use can result in fire or electric shock.
WARNING:
Do not use this product in a place where it can be splashed with water. If it is
splashed, failure, electrical leakage or fire could result.
WARNING:
If the unit malfunctions, the pressure output may be incorrect. If such a failure could
cause injury to people or damage equipment, install a suitable control system to
indicate the failure and, if necessary, to close down the process system.
WARNING:
When using an EXT I/O connector, make sure that there is no error in the wiring. If
you use this product with incorrect wiring the product can be damaged.
WARNING:
Before you switch on the power, make sure that the sensor unit and analyzer tube
are correctly connected. If power is turned on without connecting the analyzer
tube, components could be damaged.
To Next Page
Need help?
General
