Viewing the Display Screen
This list identifies the symbols you’ll see on
your display screen.
䊳
shows your current signal strength.
The more lines you have, the stronger
your signal.
䊳
means your phone cannot find a
signal.
䊳
tells you a call is in progress.
䊳
indicates you have voicemail,
numeric page or Sprint PCS
Wireless Web messages waiting.
䊳
indicates you are on the Sprint PCS
Nationwide Network.
䊳
indicates you are “roaming” off the
Sprint PCS Nationwide Network.
䊳
shows your current battery charge
strength. (Icon shown full charged.)
䊳
indicates your phone is in vibrate
mode. (Displayed when your Flip is
closed.)
Tip:
The Power Save
feature helps to
conserve your
battery power when
you are in an area
where there is no
signal.
Tip:
Display indicators
let you know
whether you are on
the Sprint PCS
Nationwide
Network or roaming
on another digital
network.
2
Getting to Know
your Phone
16 Getting to Know your Sprint PCS Phone Getting to Know your Sprint PCS Phone 17
Turning your Phone ON and OFF
Turning your Phone ON
1. Fully extend the antenna to receive the best
reception.
2. Press for two seconds.
Once your phone is ON, it displays “Searching
for Service” while your phone looks for a signal.
When your phone finds a signal, it
automatically enters Standby mode – the
phone’s idle state. At this point, you're ready to
begin making and receiving calls.
If your phone is unable to find a signal after 15
minutes of searching, a Power Save feature is
automatically activated. When a signal is found,
your phone returns to Standby mode.
Your phone searches for a signal periodically
without your intervention. You can also initiate
a
search for Sprint PCS Service by pressing any key
(when your phone is turned ON).
Turning your Phone OFF
Press for two seconds until you see
“Powering Off” on the display.
Your screen remains blank while your phone is
off, unless you’re charging the battery.
To Next Page
Loading...
