32
Function
Product
Description Option
Air
Conditioner
Ventilation
Filter Sign
○ ○
You can check the lter status
and reset the lter usage time.
If you plan to reset the default
value after the lter’s auto-
inspect status is displayed, it’s
best to clean the lter before
resetting.
• The remaining time to clean the filter is for
reference, and the actual filter status may vary
depending on the installation environment and
usage conditions.
• When dust is put on the filter, the cooling / heating
capacity is lowered with a high electricity charge,
so please clean the filter when the time comes.
• Setting the auto-inspect filter function saves the
filter’s initial status. The auto-inspect filter function
runs every 720 hours to check if the filter is
clogged and displays the results.
Wi-Fi Pairing
○ ○
A function to run the pairing
function of the Wi-Fi module
connected to the indoor unit.
In case of the old ventilation
product, the function may not be
displayed.
-
Change
Temperature
○ ○
The conversion temperature is
a function to set a temperature
by which cooling and heating
operation is automatically
converted according to a
temperature.
1~7 °C (2~14 °F)
Zone Name
○
The name of each Zone to be
used for zone control can be
determined by directly typing it
according to the user's style.
-
Comfort
Cooling
○ ○
A function to set the outdoor unit
comfort power-saving operation
stage value.
Step 1 / Step 2 / Step 3
ODU
Refrigerant
Noise
Reduction
○ ○
A function to set the refrigerant
noise reducing function of the
outdoor unit.
• This function is available only if the outdoor unit
Master / Slave setting of the installer settings is
Master.
Defrost
Mode
○ ○
A function to set the defrosting
mode operation of the outdoor
unit.
Smart Load
Control
○ ○
A function to set the active
power-saving stage value of
the outdoor unit. (Active power-
saving is a function to operate
by calculating the required
performance from the air
temperature and humidity in the
indoors and the outdoors.)
To Next Page
Loading...
