38
Air Conditioner / Ventilation Installer Settings
Function
Product
Description Option
Air
Conditioner
Ventilation
Test Run
○ ○
A function to set the test-running when
initially installing the product.
-
Central Control
Address
○ ○
A function to set the central control
address of the indoor unit when
connecting the central controller.
00 ~ FF
ESP
○
A function for setting the air volume
value corresponding to each air
volume and to facilitate installation.
Set the RPM value for each fan speed.
Temperature
Sensor (2TH)
○ ○
A function to select the temperature
sensor for determining the room
temperature.
Remote controller / Indoor unit / 2TH
Ceiling Height
Selection
○
A function to control the stage of air
volume in accordance with the height
of the ceiling in a ceiling-type product.
Low / Standard / High / Very high
Static Pressure
○
This function changes the fan speed
in the indoor FAN according to the
opening and closing quantity of
Damper.
It is available only in a duct product.
V-H: Indoor fan speed change, High
pressure
F-H: Fixed with set fan speed, High
pressure
V-L: Indoor fan speed change, Low
pressure
F-L: Fixed with the set fan speed, Low
pressure
Override
Master / Slave
○ ○
A function to prevent another mode
operation. In the function, the products
set to ‘Slave’ prevent the selection of
the opposite mode of the operation
mode of the indoor unit which is set to
‘Master.’
Master / Slave
Dry Contact
Mode
○ ○
A function which is available only when
the dry contact apparatus is separately
purchased / installed.
Manual / Auto
3 Minutes
Delay
○ ○
Temporarily cancel the 3 min. delay
function of the outdoor compressor.
※ Caution: Do not randomly set it
since it is a function used
for producing the products.
-
SEER Mode
○
Measures the driving ability of the duct
product.
ON / OFF
To Next Page
Loading...
