LGMG North America Inc.
Operation and Safety Manual
19
proper oil level. Go through the label.
4) Check for any battery fluid leakage and if the
liquid level is suitable. Add distilled water, if
required.
5) Inspect the entire machine for:
a) Cracks in welds or structural
components.
b) Machine pitting or damage.
c) All structural members and other key
components have no missing parts,
related fasteners and pins are in the
correct position, and properly tightened.
d) Install the guard rail, place the guard rail
pin in place, and tighten the retaining
bolts.
6) Check the following components for damage,
proper installation, and any missing parts or
unauthorized changes to components:
a) Battery pack and connections.
b) Electric element, wiring and cable.
c) Nuts, bolts, and all other fasteners.
d) Hydraulic hoses, connectors, cylinders,
and valves.
e) All Indicator lamps and alarms.
f) Safety props.
g) Pothole guards.
h) Platform overload components (if
equipped).
i) Scissor arm pins and fasteners.
j) Limit switches, alarms, and horn.
k) Drive motors.
l) Tires and wheels.
m) Slide blocks and liners.
n) Brake release components.
o) Ground straps.
p) Platform entry gate.
q) Platform control box.
r) Extending platform deck.
s) Keep the chassis battery tray and oil
pump tray closed and locked. Engage
the battery disconnect switch.
△
! Notice
If the platform must be elevated to
inspect any machine components, keep
the safety prop in the correct position.
Refer to Chapter 7 – Operating
Instructions.
.
To Next Page
Loading...
Need help?
General
