LGMG North America Inc.
Operation and Safety Manual
43
Brake Release Operation (For hydraulic
drive models)
1) Chock the wheels to prevent the machine
from moving.
2) Make sure all lifting devices are properly
fastened at the designated tie down/lifting
points on the chassis, and there are no
obstacles in the way.
3) Push the black brake release knob to open
the brake valve.
4) Pull the red brake release pump knob.
⑤Repeat the above procedure on opposite drive
motor. With both drive motor brake released the
machine can be moved manually.
⑥After moving the machine，return both drive
motors to the original conditions.
8.2 Transport Safety
1) Chock the machine wheels when preparing
for transport.
2) Retract and secure the extending platform.
3) Switch the key switch to the OFF position
and take out the key before transporting the
machine. Disconnect and remove the
platform control box. Store in a safe location
prior to transporting the machine.
4) Ensure the front and rear wheels are
securely chocked and the machine is
inspected to ensure there are no loose or
unsecured parts.
5) Secure the machine on the transport surface
using the tie down areas on the chassis.
6) Use at least four chains or tie straps.
7) Be sure to use chains or tie straps of
sufficient load capacity.
8) Secure the folded guard rail (if any) with a tie
To Next Page
Loading...
Need help?
General
