LGMG North America Inc.
Operation and Safety Manual
20
Chapter 5 Workstation Inspection
△
! Warning
Operation is forbidden unless the
following safe operating principles of
the machine are understood and
performed.
1) All dangerous work site conditions are
avoided.
2) Pre-Operation Inspection has been
completed.
3) The workstation has been inspected.
△
! Notice
The workstation inspection must be
performed and proper operating
procedures understood before the next
step.
4) The function test has been performed.
5) The machine is used as described in this
manual.
5.1 General Information
1) Using the Workstation Inspection
procedures, the operator can determine if the
safe operation of machine is possible from
the workstation. The operator shall carry out
this process before operating the machine
from the workstation.
2) Understanding the hazards of the
workstation are the responsibilities of the
operator. Avoid these hazards while moving,
delivering, or operating the machine.
5.2 Workstation Inspection
Be aware of the following hazards:
1) Sudden slopes, holes, or dips in the traveling
surface.
2) Bumps, ground barriers, or debris on the
ground.
3) Inclined plane.
4) Infirm or unsteady ground surface.
5) Overhead barriers and high-voltage power
lines.
6) Dangerous location
7) Supporting surface unable to bear the load of
the machine.
8) Wind and inclement weather.
9) Unauthorized personnel.
10) Other possible unsafe conditions.