LGMG North America Inc.
Operation and Safety Manual
28
Chapter 7 Operating Instructions
△
! Warning:
Operation is forbidden unless the
following safe operating principles of
the machine are understood and
performed.
1） The dangerous conditions are avoided.
2) The pre-operation inspection is always
made.
3) The workstation is checked.
4) The function test is always made before the
use.
5) The machine is used for its design purposes.
7.1 General Information
1) This machine is an electrically powered
mobile elevating work platform, consisting of
a work platform on an elevating scissors
mechanism. The vibration produced by the
running machine causes no hazards to the
operators on the work platform. This
machine can be used for carrying the
workers and their tools to the specified
height above the ground and also for
reaching the workstation above the machine
or equipment.
2) Detailed operating instructions for all
functions are outlined in this Operation
section. It is the operator's responsibility to
follow all safety regulations and descriptions
in this operation and maintenance manual.
3) It is prohibited to use the machine for any
purpose other than carrying the staff,
equipment, tool and material to the overhead
workstation.
4) Only trained and authorized personnel can
operate this machine. Each operator shall
perform the pre-operation inspection,
function test and workstation inspection
before running the machine.
7.2 Emergency Stop
1) Push the emergency stop switch on the
ground or platform controller to the OFF
position to disable all functions.
2) The recovery of any operation function must
be done by pressing the emergency stop
switch.
7.3 Emergency Lowering
Pull the emergency lowering control button
outward.
7.4 Operation from the
Ground Controls
1) Turn the key switch to the ground position.
2) Pull the emergency stop switch on the
ground and the platform to the ON position.
To Next Page
Loading...
Need help?
General
