LGMG North America Inc.
Operation and Safety Manual
33
platform inward. Do not place your hands in
places where there may be a pinch point. At
the same time, prevent the right guardrails of
the extended platform from tilting over.
8) Fold the right guardrail of the extending
platform inward. Do not place your hands in
places where there may be a pinch point.
9) Remove the two retaining pins on the upper
part of the door.
10) Fold the door guardrail from the ladder or the
ground inward. Do not place your hands in
places where there may be a pinch point. At
the same time, prevent the guardrails of the
extended platform from tilting over.
11) Fold the left guardrail of main platform from
the ladder or the ground inward. Do not place
your hands in places where there may be a
pinch point. At the same time, prevent the
right guardrails of the main platform from
tilting over.
12) Fold the right guardrail of main platform from
the ladder or the ground inward. Do not place
your hands in places where there may be a
pinch point.
13) Install the two retaining pins which were
removed back to the guardrail on each side.
On models , AS2646/AS2646E/AS3246/
AS3246E/ AS4046 /AS4046E/AS4650/
AS4650E, the platform guardrail system
consists of a folding guardrail on an extended
platform and a folding guardrail on the main
platform.
1) Fully lower the platform and lock it into the
extended platform.
2) Remove the platform controller.
3) Remove the M-shaped fixed seat between
the guardrails of the main platform and the
extended platform from the inside of the
platform and place it in the platform.
4) Remove the two retaining pins at the front of
the extended platform from the inside of the
main platform.
5) Fold the front guardrail of the extended
platform inward. Do not place your hands in
places where there may be a pinch point. At
the same time, prevent the left and right
guardrails of the extended platform from
tilting over.
6) Install the two retaining pins which were
removed back to the guardrail on each side.
7) Fold the left guardrail of the extending
platform inward. Do not place your hands in
places where there may be a pinch point. At
the same time, prevent the right guardrails of
the extended platform from tilting over.
8) Fold the right guardrail of the extending
platform inward. Do not place your hands in
places where there may be a pinch point.
9) Remove the two retaining pins on the upper
part of the door.
10) Fold the door guardrail from the ladder or the
ground inward. Do not place your hands in
places where there may be a pinch point. At
the same time, prevent the left and right
guardrails of the extended platform from
tilting over.
11) Rotate the semi-revolving door until the right
and left guardrails can be folded smoothly ,
from the ladder or the ground inward. Do not
To Next Page
Loading...
Need help?
General
