-264- v2.9
Updating Firmware
Step 1: Open the USB connector
Remove the protection cap of the USB connector.
Figure: USB protection cap
Step 2: Connect the USB cable to MySignals
Connect one side of the male-to-male USB cable to the USB connector.
Figure: USB programming cable
Step 3: Connect the USB cable to the PC
Users have to connect the device to the computer where the Smart Devices App is installed using the USB cable
provided.
Now open Libelium Smart Devices App . If you do not have Libelium Smart Devices App already installed in your
PC, then go to the Development section of Libelium website to download it.
To Next Page
