-265- v2.9
Updating Firmware
Step 4: USB setting
Select the corresponding serial port by going to tools/serial port. If you are unable to see the proper USB port
maybe you should install the latest FTDI drivers on your PC. Then, refresh the “USB settings” block which is in the
middle part of the tab, clicking in “refresh” button. Once done it, the port where the device has been connected
must be selected.
Figure: USB setting
Step 5: Download rmware versions
First of all click on the “Search new rmware updates” button. Then mark the desired version and click on
“Download checked” button.
Figure: Firmware download
Step 6: Burn the new rmware
When this item is downloaded, a disk icon will be displayed near it. Once the rmware is downloaded, it is ready
to be installed using the “Install Firmware” section at the bottom. In the drop-down will appear all downloaded
versions. Select one and then hit on “Install” button.
Figure: Firmware downloaded
Figure: Firmware selected
To Next Page
