To Next Page

To Previous Page

lci1.com 574-537-8900 Rev: 03.02.21

Ground Control

Leveling OneControl

Touch Panel (3K-5K)

Installation and Owner’s Manual

(For Aftermarket Applications)

CCD-0002700

1. Dry t the mounting plate (Fig.20C) and the leveling

sensor (Fig.20B) to the crossmember (Fig.20A). The pre-

drilled holes closest to the rounded edges are for mounting

the sensor to the plate. Mark on the plate where the sensor

will set.

Fig.20

NOTE: Make sure there is a space between the sensor

and crossmember so the wire harness is not pinched.

NOTE: The wire harness MUST be pointed toward the

front of the trailer. Orientation is imperative for the correct

operation of the leveling system.

2. Attach the sensor (Fig.21A) to the mounting plate

(Fig.21B) using two #12 x 1” screws (Fig.21C).

Fig.21

NOTE: To avoid cracking the mounting sensor housing,

do not over-tighten the screws.

3. Attach the mounting plate and sensor assembly

(Fig.22B) to the crossmember (Fig.22A) using two #12 x 1”

screws (Fig.22C). Make sure that the plate is centered side

to side on the frame and that the sensor is oriented properly.

See gure 18, sections A and B, for location clarication.

Fig.22

4. Connect the sensor harness to the 3-pin Deutsch

Connector on the sensor (Fig.23A) and run the harness

through the frame and up to the compartment where the

controller will be mounted.

Fig.23

Lippert Components ground control TT User Manual

Other manuals for Lippert Components ground control TT