29
lci1.com 574-537-8900 Rev: 03.02.21
Ground Control
®
TT
Leveling OneControl
®
Touch Panel (3K-5K)
Installation and Owner’s Manual
(For Aftermarket Applications)
CCD-0002700
OneControl Touch Panel Error
Message Troubleshooting
OneControl Touch Panel Error Messages
Touch Panel MessageTouch Panel Message Why?Why? What should be done?What should be done?
“EXCESS ANGLE”
Unsecured sensor. Check and secure sensor placement.
Uneven or sloped site. Relocate the trailer.
“EXCESSIVE ANGLE” Excessive angle reached during manual operation.
Stop manual operation and reset jacks to a more
level state. The code will self-clear. There is no
need to hit “OK.”
“BAD CALIBRATION” Trailer zero point was not set correctly. Reset zero point.
“FEATURE DISABLED”
Hitch recognition requested but no hitch height set.
Perform AUTO LEVEL sequence to establish
hitch height.
Zero point not set. Set zero point.
“LOW VOLTAGE”
Bad connection or wiring. Check wiring - repair or replace.
Discharged or bad battery. Test battery voltage under load - charge or replace.
“OUT OF STROKE”
Unsecured sensor. Check and secure sensor placement.
Uneven or sloped site. Relocate the trailer.
“EXTERNAL SENSOR” Bad connection or wiring. Replace or repair connection to rear remote sensor.
“JACK TIME OUT” System could not level in expected time. Check disposition of jacks.
“AUTO LEVEL FAILURE”
Unsecured sensor. Check and secure sensor placement.
Voltage drop. Test battery voltage under load - charge or replace.
“FUNCTION ABORTED” User has aborted an automatic leveling sequence. Restart the sequence.
“HALL POWER SHORT”
Short circuit detected on one or more of the
jack hall effect power lines.
Check harness and replace or repair.
“CAN’T COMPLETE
LEVEL IN THIS
LOCATION. PLEASE
RELOCATE RV TO
FLATTER TERRAIN”
The trailer is parked on a steep incline during
auto level. The front cannot be leveled and the
front jacks are already fully retracted.
Relocate the trailer.
To Next Page
Loading...
Need help?
General
