Lippert Components ground control TT - Zero Point Calibration

33
lci1.com 574-537-8900 Rev: 03.02.21
Ground Control
®
TT
Leveling OneControl
®
Touch Panel (3K-5K)
Installation and Owner’s Manual
(For Aftermarket Applications)
CCD-0002700
Zero Point Calibration
The “Zero Point” is the programmed point that the trailer
will return to each time the Auto Level feature is used. The
“Zero Point” must be programmed prior to using the Auto
Level feature to ensure the proper operation of the system.
The “Zero Point” feature is available on the OneControl
Touch Panel or the OneControl App.
NOTE: Images depicted are from the OneControl Touch
Panel.
1. Prior to starting this procedure, double check all
connections on the controller, jacks and touch panel.
2. When calibrating Zero Point, the user has full manual
control over the jacks. See Basic Jack Operation In Manual
Mode in the Operation - OneControl Touch Panel section
to adjust to the desired level position. Press the ENTER
button (Fig.35G) to set.
3. Press the gear icon (Fig.50A) for “options.”
4. The screen will show “WARNING: ADVANCED
FEATURE” (Fig.50B).
Fig.50
A
B
5. Click “YES” to continue.
6. The screen will show “SET UP: Zero Mode Press
Enter” (Fig.51).
7. Press the ENTER button (Fig.51A).
A
8. The touch panel will present options for further leveling
of the trailer if needed. The screen will also state “ZERO
POINT CALIBRATION - Press Enter to Set” (Fig.52).
9. Press ENTER button (Fig.52A).
Fig.51
10. Screen will show “Zero point set!” (Fig.53).
Fig.52
A
Fig.53