Lippert Components ground control TT - 5 K-Short Jack Manual Override

32
lci1.com 574-537-8900 Rev: 03.02.21
Ground Control
®
TT
Leveling OneControl
®
Touch Panel (3K-5K)
Installation and Owner’s Manual
(For Aftermarket Applications)
CCD-0002700
5K-Short Jack Manual Override
Top of Jack Motor Override:
Tools needed: 3/8” drive ratchet and extension (no socket)
1. Find the port on the top of the jack motor (Fig.46A).
2. Remove the rubber plug (Fig.46A).
3. Insert the 3/8” drive ratchet into the port (Fig.47A).
4. Turn the override until the jack extends or retracts to
desired position.
5. Replace the rubber plug (Fig.46A).
Jack Manual Override Nut:
Tools needed:
¾” socket wrench
1. Locate the manual override nut (Fig.45A).
2. Place
¾” socket wrench over the manual override nut
(Fig.45A) and turn the override nut until the jack extends or
retracts to desired position.
Fig.45
A
Bottom of Jack Motor Override:
Tools needed:
3/8” drive ratchet and extension, 5/16” socket
1. Find the port on the bottom of the jack motor (Fig.46B).
2. Remove rubber plug (Fig.48A) on the bottom of the jack.
Fig.46
A
Fig.47
A
B
3. Insert
5/1 6” socket into the port and onto the nut (Fig.49A).
4. Turn the override until the jack extends or retracts
to desired position.
5. Remove the drive ratchet from the port.
6. Replace the rubber plug (Fig.48A).
Fig.48
Fig.49
A
A