03-09-05 2
5 INSTALLATION 21
Cable requirements 21
Analog output 22
Scale factor current output and engineering units 22
Load conditions for analog output. 25
Alternative connections for valid output 25
Cable crosstalk. 26
Electrical installations, examples 27
Mechanical installation. 29
For a single SLS sensor system 30
For a dual SLS sensor system 30
Hints for measurements 32
Material 33
Unstable thickness reading 35
Surface texture. Static texture error 35
Temperature of the material 37
Geometry of the material. Secondary reflections 37
6 SERVICE AND MAINTENANCE 38
Keeping the front glass clean 38
Visual check for damage 38
LED-indicators (Yellow and Green) 39
7 APPENDIXES 40
Appendix A, Revision page 40
Appendix B, Accessories 40
Appendix C, SLS-asynch-1, protocol 40
Appendix D, SLS power unit 24 51
Appendix E, Connection table 53
Appendix F, Quality Record 54
Appendix G, Dimensional drawings 57
LMI Technologies AB
Ögärdesvägen 19 A
Box 250,
S-43325 Partille
SWEDEN
Tel: +46 (0)31 336 25 10
Main +46 (0)31 336 25 00
Fax: +46 (0)31 44 61 79
Internet: http://www.lmint.com
LMI Technologies (USA), Inc
.
21455 Melrose Ave. Suite
22
SOUTHFIELD MI 48075
USA
Tel: +1 248 355 5900
Fax: +1 248 355 3283
LMI Technologies BV
Valkenburgweg 223
6419 AT Heerlen
The Netherlands
Tel: +31 45 850 7000
Fax: ++31 45 574 2500
LMI Technologies Inc.
205-7088 Ventura Street
Delta, BC, V4G-1H5
Canada
Tel: +1 604-940 0141
Fax: +1 604-940 0793
Printed in The Netherlands
To Next Page
Loading...