03-09-05 38
6 SERVICE AND MAINTENANCE
It is possible during service and maintenance that unintentional
exposure to laser light may occur takes extra care not to look into
the laser aperture of the SLS sensor unless you are certain that
the laser beam is turned off. Tools that are used during
installation may give mirror like reflections. If possible wear
protective goggles.
The laser beam of the SLS sensor cannot burn skin.
No changes or modifications may be made to the sensor or its cable unless you
have a written permission from LMI Technologies. If the sensor is opened or
modified without permission, warranty is voided.
For service, contact the LMI Technologies office closest to your location or your
local distributor.
It is recommended that the following be performed on a regular basis depending
on environmental conditions.
Keeping the front glass clean
1.Turn the power OFF.
• If LMI Technologies provides the power supply: remove the key.
• Other wise: make sure that the power cannot be unintentionally turned on.
2. Wipe the front glass clean using a soft, lint free cloth, if necessary moisten with
mild cleaning fluid (e.g. cleaning alcohol).
3. Check the front glass for adherent particles or damage. If damaged, contact
your LMI Technologies representative.
4. Turn the power ON.
Visual check for damage
1 Turn the power OFF
If the power supply is provided by LMI Technologies: remove
the key.
Other wise: make sure that the power cannot be unintentionally
turned on.
1 Check the sensor for mechanical damage.
2 Check the cable for damage.
3 Check that mounting screws/bolts are tightened.
4 Check that any extra accessories are working.
5 Check filters and hoses for air purge.
6 Check calibration block.
7 Turn the power ON.
To Next Page
Loading...