03-09-05 39
LED-indicators (Yellow and Green)
1 Both LED-OFF
Main power to the SLS is OFF, Check the +24 VDC supply.
2 Both LED-ON
• Power up and initialization sequence (approximately 10
sec.)
• The sensor set-up menu is active (SLS5000 and SLS6000
only, see Appendix E Parameter Setup.)
3 Green LED-ON
Laser is ON
Object in measurement range (or in a false measurement
range, check distance
between sensor and object!)
Laser spot invisible to the naked human eye
4. Yellow LED-ON
• Laser is OFF or
• Laser is ON but no object in the measurement range or
• Laser is ON with an object in the measurement range
Indication that the Laser is faulty, contact LMI Technologies!
5. Yellow and Green LED is blinking
Faulty sensor condition, contact LMI Technologies!
To Next Page
Loading...