The underside of each of the inner legs of the Vulcan table has a 1/2-13 tapped hole.
Four leveler pads have been furnished with the table. BEFORE REMOVING THE TABLE
FROM THE SHIPPING SKIDS completely thread the adjustment nut as shown in the
illustration, then fully thread a leveler into each leg.
DO NOT ANCHOR THE TABLE TO THE FLOOR. A Lockformer installation
technician will level the equipment and secure it to the floor.
SHIPPING SKID
INNER LEGS (4)
BOTTOM VIEW OF TABLE LEG
LEG
LEVELER
ADJUSTMENT
NUT
INSTALLING THE TABLE LEVELERS
H. WEISS MACHINERY & SUPPLY
H. WEISS MACHINERY & SUPPLY
PHONE: (718) 605-0395 - www.hweiss.com
To Next Page
Loading...
