4. REINSTALLATION AND ASSEMBLY OF THE VULCAN TORCH HEAD
Regular maintenance of the torch head includes resetting the torch height for the stock being cut,
and cleaning; as described at the end of this section.
If a torch head is ever to be removed and a new one installed, or if a torch head has to be reset, use
the following procedures:
Disconnect primary power leads and gas tanks before beginning actual removal of torch head from
main machine.
1. Complete head assembly in place on bracket.
PHOTO 1
Page 2
H. WEISS MACHINERY & SUPPLY
H. WEISS MACHINERY & SUPPLY
PHONE: (718) 605-0395 - www.hweiss.com
To Next Page
Loading...
