Lode BV Excalibur Sport
43
B Programmable Display Unit 928811
B.1 Installing the Programmable Display Unit (option 928811)
When the option 928811 is ordered later on, it should replace the standard Control Unit.
Replacement should be carried out by service personnel only. Operation of the Programmable
Display Unit is described in B.3. Follow the instructions below to replace the Unit:
1. Unscrew the 4 Elot PT Screws of the Ergometer-controller on bottom part side (Fig. 3:
Remove the controller top, item 1)
2. Lift the Ergometer-controller top (Fig. 3: Remove the controller top, item 2) a little.
3. Pull the connector of the flatcable (Fig. 3: Remove the controller top, item 4) out of the
header (Fig. 3: Remove the controller top, item 3)
4. Take the Ergometer-controller top P-type.
5. Mount the connector of the flatcable to the connector of the P-board of the ergometer
controller top P-type. (Fig. 4: Controller top P-type, item 1)
6. Place the controller top on the bottom part of the ergometer-controller.
7. Fasten it with the 4 Elot PT screws
Fig. 3: Remove the controller top
To Next Page
Loading...
