Lode BV Excalibur Sport
65
C Heart rate option 928826
C.1 Connecting the Heart rate system (option 928826)
To install a heart rate option purchased afterwards, follow the instructions given below. The
heart rate option should be mounted to the analog i/o connector. Position the receiver within 1
meter of the test subject heart position.
C.2 Using the Heart rate option
The heart rate option is automatically recognized by the ergometer. The Polar belt should be
mounted at the test subject’s heart height around the chest with Polar trade mark pointing
forwards from the middle of the chest. The belt should not be to loose. If you have a weak
signal, check following tips:
• Wet the contacts on the right and left backside of the Polar belt for good contact
• Stay near the receiver (within a range of 0,8 meter)
• Due to the integration measurement principle it can take a few seconds before the
readout on the display shows the correct value. Be patient.
• The test subject should be positioned in such way that a straight virtual line can be
drawn between the Polar trade mark on the belt and the receiver inside the display
unit, or placed in front of the Test subject.
•
To Next Page
Loading...
