Lode BV Excalibur Sport
63
Pressing PROT (protocol) will bring you back to the normal exercise protocol screen.
Pressing DISP (▼▲) will allow you to toggle between the BP parameters and de default
selected parameters. START will start the blood pressure measurement. Pressing DISP will
show as next display the actual pressure p on the second line:
On the third line are still the selected parameters. Pressing DISP again will show as next
display the actual pressure p.
Whenever the test subject is allowed to or has to stop the exercise test, the recovery button
has to be pressed the following will appear on screen:
In this example the recovery phase will bring the workload down to 50 watt. The timer is
showing 10:30 seconds and will go on with the registration during the recovery as long as the
RPM is above 30 (the BPM can still be measured when BPM is displayed at the confirmation
button). To stop the recovery phase press the ESC button to go back to the PROTOCOL
menu. In MANUAL, TERMINAL or ANALOG the BP function is the same as described
above.
B.3.8.5 Protocol delete
Rec P= 50W t=10:30
P= 50W 60 rpm
♥ = 174/min
esc esc
BPM
P= 30W 60 rpm
♥ = 114/min
PROT dis ►
BPM
p = 123 mmHg
P= 30W 60 rpm
PROT dis ►
BPM
p = 123 mmHg
♥ ♪
P= 30W 60 rpm
PROT dis ►
To Next Page
Loading...
