Logic DLC NET Series

To Next Page

To Previous Page

USE AND MAINTENANCE MANUAL – DLC

NET

Series

Installation

LOGIC S.r.l. - M0145Db.docx

Mod. L0006A01 of 30/05/2016

Page 27 of 78

Below are listed the serial configuration parameters for communication with

DLC

NET

. The parameters, also shown in Figure 17, are to be set on BA488C to

have a correct communication:

Table 9. Serial port parameters for communication with BEKA

BA488C

Parameter

Value

Transmission

Asynchronous

Baud rate

19200

Word

8 bits

Stop bit

Parity

None

Set up the KeyPad parameter to "Internal" to use the integrated buttons of

BEKA.

Main Page

Figure 1. Equipment Back Serigraphy11
Figure 2. Diagram of Operation and Power Supplies13
Figure 3. Mechanical Drawing of DLC NET15
Figure 4. DLC NET -WM Mechanical Drawing16
Figure 5. DTR NET -WM Mechanical Drawing16
Figure 6. Layout of the Terminal Blocks, Profibus-DP18
Figure 7. Layout of the Terminal Blocks, Profinet18
Figure 8. DLC NET -WM Terminals (Model with On-Board Keyboard)19
Figure 9. DTR NET -WM Terminals (Model with External Keyboard)19
Figure 10. Power Supply Connection20
Figure 11. Load Cells Connection 6 Wires21
Figure 12. Load Cells Connection 4 Wires21
Figure 13. Load Cells Connection 6 Wires with Zener Barrier Z-SET3-PF22
Figure 14. Load Cells Connection 6 Wires with Active Barrier D1063S23
Figure 15. Connection to the Junction Box JBOX-V3(EX1)24
Figure 16. Connection of DLC25
Figure 17. Connection of DLC26
Figure 18. Instrument Connection to Profibus-DP28
Figure 19. Instrument Connection to Profinet29
Figure 20. Connection to External Buttons through Potential-Free Contacts30
Figure 21. External Buttons Connection from Active Source31
Figure 22. Connection to Setpoint Output31
Figure 23. Input and Output Connections for Dosing32
Figure 24. Analog Output Connection 0-20 Ma or 4-20 Ma33
Figure 25. Printer Connection through RS23234
Figure 26. Signal Chart for the Data Weight Reading through Parallel Output35
Figure 27. Connection for Parallel Interface Type PNP36
Figure 28. Connection for Parallel Interface Type NPN37
Figure 29. Switch SW2-1 for Setting Speed ADC39
Figure 30. Termination Resistance Setting RS485 Serial Port39
Figure 31. Hardware Setting for Siemens PLC40
Figure 32. Reading Instrument with PLC42
Figure 33. Operator Interface of DLC43
Figure 34. Operator Interface with Logic DLC3-RD43
Figure 35. Operator Interface with BEKA44
Figure 36. Application of the Instrument as a Batcher61
Figure 37. Timing Activation Outputs for the Dosing of Automatic Components62

Logic DLC NET Series

Table of Contents