Logosol B1651 - Lubrication Points; The Tube Sections of the Rail Frame; The Top Rail Sections on Which the Saw Bogie Runs; The Blade Tensioning T-Handle

LUBRICATION POINTS
In order to keep the sawmill in good condition for many years, and to have a problem-free ownership, it is
important to lubricate the sawmill components as described below.
• Lubricate immediately after assembly, before starting to use the sawmill.
• Lubricate every 50 hours of operation, but at least once a year.
The lubricants you should use on your sawmill are:
Supero SKU: 9999-000-5115
Universal lubricating oilSKU: 9999-000-5105
Silicone SKU: 9999-000-5110
Grease ISO-L-XCCIB2
THE TUBE SECTIONS OF THE RAIL FRAME
Lubricant: Universal oil
Insert the spray can nozzle into all openings and spray the inside of the tube sections to protect against
corrosion.
THE TOP RAIL SECTIONS ON WHICH THE SAW BOGIE RUNS
Lubricant: Universal oil
THE BLADE TENSIONING T-HANDLE
Lubricant: grease or Supero
Unscrew the T-handle and grease its threads generously.
THE LIFTING CHAINS AND CHAIN TRANSMISSION OF THE SAWHEAD
Lubricant: Supero
Lubricate the whole chain.
THE LIFT WINCH SHAFT
Lubricant: Supero
Lubricate from the outside on both sides.
THE THROTTLE WIRE AND HANDLE OF THE ENGINE
Lubricant: Supero
Note! The handle and throttle are not applicable for B1651.
Lubricate the handle joint and spray oil into the wire from its ends. If the wire is difcult to move, remove the
wire from its coating and lubricate the whole wire and spray oil into the wire coating.
THE LEGS OF THE SAW BOGIE
Lubricant: Silicone
Lubricate the sliding surfaces of the sawhead and the plastic guides.
USER MANUAL
110