ADJUSTING THE RAIL FRAME
TIP
Use shims under the rail sections, so that they stay in the right position while you are
tightening the bolts.
IMPORTANT
This step is crucial for the precision of the sawmill. Be careful and put some extra time into this
step.
Measure along a string to check that the
distance between the string and the rail is
the same along the whole rail. To adjust the
levelness of the rail, move the rail sections
up or down at the points where the rail is not
level.
When the rail is adjusted level, check that all
the rail sections are level at the joints and
that the inner and outer rail sections are at
the same height. All joints should be as level
as possible.
Adjust and tighten the bolting step by step.
When one side of the rail frame is adjusted
along its whole length and the joints are
level, tighten all boltings on this side of the
bed. Then, repeat all the adjustment steps
on the opposite side of the rail frame to
complete the adjustment.
USER MANUAL
44
To Next Page
Loading...
