Control panel
- 37 -
01.21 909.2669.9-02
A
Welding process
30 The selection switch on the left
allows you to select the individual welding process.
31 LED Direct Current (DC)
lights up if you select the TIG-DC welding process.
32* LED TIG Alternating Current (AC)
lights up if you select the TIG-AC welding process.
33 LED electrode direct current (DC)
light sup if you select the electrode-DC welding pro-
cess.
34* LED electrode alternating current (AC)
lights up if you select the electrode AC welding pro-
cess.
B
Mode
47 The selection switch on the top right
allows you to select the individual modes.
44 LED 2-stroke
lights up if you select the 2-stroke mode.
45 LED 4-stroke
lights up if you select the 4-stroke mode.
46 LED Pulse
lights up if you select the pulse mode.
C
Welding parameters
48 The selection switch on the bottom right
allows you to select the individual welding parameters.
41 The knob
allows you to adjust the welding parameters.
38 The 7-segment display
displays the welding parameters.
The right-hand decimal point lights up with an acti-
vated remote control.
35 LED Gas pre-ow time
lights up for selected parameters. The gas pre-ow
time can be changed with knob (41).
36 LED Upslope
lights up for selected parameters. The upslope can be
changed with knob (41).
37 LED Main current I1
lights up for selected parameters. The main current is
set with knob (41).
39 LED Pulse frequency
lights up for selected parameters. The pulse frequency
can be changed with knob (41).
40 LED Second current I2
lights up for selected parameters. The second current
can be changed with knob (41).
42 LED Downslope
lights up for selected parameters. The downslope can
be changed with knob (41).
43 LED Gas post-ow time
lights up for selected parameters. The gas post-ow
time can be changed with knob (41).
*) Only for AC/DC
To Next Page
Loading...
Need help?
General
