Using the PC/Mac Client Software
17
17.31 Configuring Event Settings
The Event Settings tab allows you to configure how the system behaves when a system
event occurs (e.g. hard drive error, video loss). This is useful if you want your DVR to notify
you if there is a potential system problem.
To configure the system event settings:
1. Click the Remote Setting tab, and click Advanced>Events.
2. Configure the following:
• Event Type: Configure the type of event that triggers the system to send an alert.
• Enable: Select Enable to activate the system to notify you if an event occurs.
• Buzzer: Select OFF to enable/disable the system buzzer or select the duration of
the system buzzer after an event occurs.
• Show Message: Select the checkbox to enable the system to display a warning
message when an event occurs.
• Send Email: Select the checkbox to enable email notifications. Email notification
must be enabled.
• Alarm Out: Select Enable for the system to trigger alarm out devices when an
event occurs (alarm devices required; not included).
• Latch Time: Configure the system latch time after an event occurs.
3. Click Save to save changes.
17.32 Configuring Auto-Reboot
Auto-reboot allows the system to restart automatically at a set time or date. This improves
system stability.
To configure Auto Maintain:
1. Click the Remote Setting tab, and click Advance>Maintain.
2. Click the Auto Reboot drop-down menu, and select Enable or Disable to activate or
deactivate the auto-reboot feature.
#LX400012; r. 2.0/12066/12066; en-US
97
To Next Page
Loading...
Need help?
General