Lorex LH150 ECO4 SERIES - Configuring Recording Parameters; Configuring the Recording Schedule

Using the PC/Mac Client Software
17
4. Drag your mouse cursor over the areas you wish to black out. A red box indicates the
area that is masked (blocked out).
• To remove a privacy area, click on the red box, then click the Delete button.
5. Click Save to apply your settings.
17.12 Configuring Recording Parameters
1. Click the Remote Setting tab, and then click Record>Rec Parameters.
2. Configure the following:
• Channel: Select the channel you wish to configure.
• Record: Select Enable or Disable to start or stop system recording.
• Pack Duration: Select the duration of each saved file on the system. For example,
if you select 15 minutes, then every file will contain 15 minutes of footage.
• Pre-record: Select whether to enable or disable pre-recording.
3. Click Save to apply your settings.
17.13 Configuring the Recording Schedule
1. Click the Remote Setting tab, and then click Record>Schedule.
#LX400012; r. 2.0/12066/12066; en-US
85