Using the Main Menu15
6. Click Firmware Update.
7. Follow the on-screen instructions to update the firmware.
WARNING
Do not remove the USB flash drive or power off the DVR during the firmware update. Wait for the
system to reboot.
15.8.4 Restoring to Factory Default Settings
Restoring to factory default settings reverts any setting changes you have made to their
original settings. This does not affect the recordings saved on the DVR. You can reset a
single menu, or all menus.
To load system defaults:
1. Right-click to open the Menu Bar and click the Main Menu button (
).
2. Click Advanced. Then click Load Default.
#LX400012; r. 2.0/12066/12066; en-US
67
To Next Page
Loading...
