Replacing the Hard Drive (LH150 Series)
24
3. Disconnect the power and data cables.
4. Next, remove the hard drive from the housing. This step depends on if you are using a
3.5” or 2.5” hard drive:
If your system has a 3.5” hard drive:
4.1. Remove the 4 screws holding the hard drive bracket and remove the bracket from the DVR.
4.2. Remove the 4 screws securing the hard drive to the bracket and remove the hard drive from the
bracket.
4.3. Replace the hard drive bracket and hard drive bracket screws.
If your system has a 2.5" hard drive:
4.1. Turn the DVR over carefully. Hold the hard drive in place and remove the 4 screws securing the
hard drive. Keep holding the hard drive and turn the DVR back over. Remove the hard drive
from the DVR.
WARNING
Make sure to hold the hard drive in place while removing the hard drive screws and turning
the DVR to avoid damaging the DVR.
5. Replace the DVR cover. Replace the side and cover panel screws.
#LX400012; r. 2.0/12066/12066; en-US
144
To Next Page
Loading...
