Using the Main Menu13
To configure Email Alerts:
1. From the Main Menu, click
and then select Network>Email.
2. Check Enable to enable email notifications.
If you want to use Lorex’s email server (recommended):
1. Under Mail Select, select Lorex Mail to use the Lorex email server to send out alarm
notifications. This is the recommended setting.
2. Configure the following:
• EmailSchedule: Click Setup and select the days you want email alerts to be
enabled.
• Receiver: Enter the email address that will receive alerts.
• Sender: Enter the sender’s email address.
• Subject: Enter the subject line for the email alert.
• Interval: Enter the interval between alert emails.
• Health Enable: Check to enable health check emails. Health check emails will be
sent periodically to ensure that the system is functioning normally. If you enable
health check emails, enter the Interval in minutes below.
NOTE
You must enable the Snapshot option for motion detection on each camera you would to receive
a jpg image attachment of the camera image. For details, see 13.3.8 Configuring Motion Detec-
tion, page 59.
3. Click Test to send a test email.
4. Click OK to save settings.
If you want to use Gmail or Yahoo Mail:
1. Under Mail Select, select Gmail or Yahoo Mail.
#LX400070; r. 1.0/27147/27147; en-US
57
To Next Page
Loading...
Need help?
General
