Lorex LNR110 Series - Removing the Hard Drive

LNR110 Series Hard Drive Installation
19
7. Turn the NVR over carefully. Tighten the hard drive screws (4x) to secure the hard
drive.
CAUTION
Hold the hard drive in place when turning the NVR over to prevent damage to the NVR.
8. Replace the cover and cover screws (6x).
NOTE
After installation, you must format the hard drive in order to use it with the system. See 13.3.17 For-
matting the Hard Drive, page 67.
19.2 Removing the Hard Drive
CAUTION
Make sure that the system is OFF and ALL power adapters have been disconnected before removing/in-
stalling the hard drive.
1. Power off the system, and unplug all cabling from the system.
2. Turn the NVR over and remove the cover screws (6x).
#LX400070; r. 1.0/27147/27147; en-US
164