Using the System
8
The Quick Menu has the following options:
• View: Select a camera in full-screen or select a multi-channel display.
• PTZ: Access controls for PTZ cameras (not included).
• AutoFocus: Access zoom/focus controls for auto-focus cameras (not included).
• Camera Setting: Configure image settings for cameras.
• Info: Opens the system information window.
• Sequence: Click to start/stop sequence mode.
In sequence mode, the system will automatically cycle through connected cameras
every few seconds. A
will appear to show that sequence mode is on.
Click the icon to pause sequence mode on the channel that is currently shown (icon
changes to
). Click again to resume sequence mode.
Right-click and select Sequence to return to normal viewing mode.
• Disable Beep: Turns off the beeping noise.
• Search: Search/playback recorded video. See 10 Search (Playback), page 28.
• Manual Control: Click Record to open the Record menu to select manual recording
options. See 9.3 Setting up Scheduled or Manual Recording, page 25.
• Device Search: Open the Device Search menu to manage IP cameras over the local
network.
• Main Menu: Open the Main Menu. See 13 Using the Main Menu, page 44.
8.3 Adjusting Camera Image Settings
Use the Camera Setting menu to adjust image settings for your cameras.
To adjust image settings:
1. Right-click on the channel you would like to configure and select Camera Setting. En-
ter the system password if prompted.
#LX400070; r. 1.0/27147/27147; en-US
18
To Next Page
Loading...
Need help?
General
