38
Appendix G: Power Failure Indicator
Appendix G: Power Failure Indicator
A power failure may interrupt recording modes on the system. After power is restored, the
following will occur:
• The system will restart in Auto
Sequence Mode + Motion Recording - this ensures that some
form of recording will be immediately active on the system.
NOTE: If y
ou had a different display view or recording mode set when the power failure
occurred, you will need to re-apply the previous display view and recording mode.
• A flashing Power Failure icon ( ) appears on-scr
een. The Power Failure icon indicates
that a power failure occurred while the system was actively recording (i.e. "REC" icon was
on-screen)
NOTE: The flashing ic
on appears only if the system was actively recording when the power
failure occurred. The flashing icon will disappear when you press buttons on the
receiver or remote control.
To Next Page
Loading...
Need help?
General
