Operating Instructions
Notes:
1. When charging, ensure that the air in the room is unblocked and away from open flames, and do not splash
electrolyte on human body or clothes, so as to avoid accidental injury;
2. During charging, the electrolyte temperature shall not be higher than 45℃. If it reaches this temperature,
in order to prevent accidental danger, the charging current shall be halved or stopped to cool, but the charging
time shall be extended accordingly;
3. At the end of charging, disconnect the power supply before disconnecting the power supply from the pole,
so as to prevent fire or explosion caused by friction fire.
Starter motor
The engine shall have a good starting performance. When the ambient temperature of the engine is not lower
than -5℃, the starting time shall be less than 5 seconds; in any state, the engine starting time shall not exceed
15 seconds; when starting repeatedly, the interval shall not be less than 2 minutes. When it is difficult to start
in winter, the diesel engine shall be preheated before turning on the starting motor. If the diesel engine fails
to start for three consecutive times, stop starting and check the cause of the fault. Do not use the starter motor
for a long time or for many consecutive times, so as not to damage the starter motor and battery.
During starting, when the starting switch is released, if the starting motor solenoid switch can't be
automatically turned off and the starting motor continues to run, the key shall be turned to the "OFF"
position immediately, then the battery power supply system shall be cut off, causes shall be found out and
startup shall be carried out after troubleshooting.
Lighting and signal devices
Lighting and signal devices are mainly used to illuminate the surrounding environment or the supporting
agricultural machinery when tractors work at night or during transportation. In case of faults, stop the machine for
inspection in time. In case of any damage, replace the accessories of the same model as required, and do not
replace other substitute products at will.
Generator
Always remove the dust and oil pollution on the exterior of the generator, especially the dust and oil
pollution on the terminals, and keep the wiring in good condition. Tension of V belt of the generator shall be
appropriate. If it is too loose, the V belt pulley will slip, resulting in insufficient power generation. If it is too tight,
the bearing wear will be accelerated. Generally, it is advisable to press with force of (29.4 ~ 49.0) N in the middle
of V belt with a distance of (15±3) mm.
To Next Page
