Instrument
The tachometer and coolant temperature meter are mainly used to monitor the working condition of diesel
engine. The fuel gauge is used to monitor the remaining condition of diesel oil level. The hour meter is used to
record the working hours of the engine. The charging indicator lamp is used to monitor the working condition of
the generator. The oil pressure indicator is used to monitor whether the engine lubrication system works normally.
Therefore, the working condition of the instrument shall be observed frequently, and if there is any abnormality,
the machine shall be stopped in time for inspection and troubleshooting.
Auxiliary electrical equipment
Fuse box: There are 12 gears for the fuse box in total. With spare fuse blades of each specification. Fuses are
mainly used to protect electrical equipment, and their specifications shall meet the requirements of
drawings. If there are too many blows, the causes of faults shall be checked and eliminated in time. It is
strictly forbidden to arbitrarily change the specifications of each fuse, otherwise the electrical equipment
will be damaged.
Ignition lock: the ignition lock is used to connect the whole vehicle circuit (engine start, etc.). Insert the key
into the ignition lock hole, turn it clockwise to ON position to close the whole vehicle circuit and start
preheating. Turn clockwise to ST position to turn on ECU to control engine starting. After startup of the
diesel engine, the key will automatically return to ON position after releasing. The key is always in the ON
position when the tractor is working. When the tractor stops working for a long time, the key shall be
removed to disconnect the electrical circuit of the whole vehicle.
To Next Page
